How to operate color steel tile press

1. The user shall first set the length value and plan number, and then select the running option through the "select" key, and then press the "ok" key to realize automatic operation. When the completion number is less than the plan, the system starts running until the two are equal. When the completion number is greater than or equal to the planned number, the operation will start. Only one plate will be rolled and the cutting will be finished. Press the reset button to stop the car.

2. During the trial rolling, please do not open the oil pump to avoid the loss caused by the wrong length. After rolling, press the reset button, and then use a ruler measure their actual length, usually rolled out with the user set the length of the length of the error, the error of adjustment on the front panel of the reoccupy after "incised" button and "return" button to finish cutting. When the length of the display and the actual length has a fixed deviation, the user can be adjusted by the following methods: such as: set length is 2000 mm, the actual length is 1998 mm, set set length is 2002 mm, so the actual length is 2000 mm.

3. Oil pump switch is used to control the start and stop of oil pump. Before running, please turn on the oil pump to provide pressure for the hydraulic system. After the oil pump runs, pay attention to whether the direction of the oil pump should be consistent with the direction of the arrow. If not, please replace any two of the three phase electricity in the oil pump motor.

4. The buttons of cutting down and returning control the operation of cutting tool. If press the cut and return buttons are invalid, it should be considered whether the oil level of the hydraulic oil tank is too low. In addition, the operation of the limit switch in front of the cutter will stop automatically during cutting and returning.

5. Forward and backward are controlled by the inverter to control the forward and reverse operation of the host machine, and its speed can be controlled by the high-speed/low-speed switch on the panel. Be sure to put the speed switch at high speed during automatic operation.

6. If the host machine is not running after starting operation, the arrow on the display indicates that the cutter is not in the upper limit. Please open the oil pump. If the host machine is 150mm before parking and does not enter low-speed operation, the accuracy of the rolling plate cannot be guaranteed.